Catalog » Hunter Engineering

Quick Check™ System



Quick Check™ System

Hunter's Quick Check™ inspection system performs a comprehensive vehicle inspection in under two minutes. By gathering valuable information about a vehicle's alignment, brake performance, battery health, diagnostic codes, and tire health, Quick Check allows shops to check every car, increasing revenue and improving customer retention.


Hunter Engineering

Technical Specs

Site Specifications

Power Requirements: 115/230v, 15 amp*, 50/60 Hz 1 phƗ
Air Supply: Req. (SI Units) 90-150 PSI (6.2-10.3 bar)
Min. Concrete Spec.: 3 in. (76 mm) thick, 3000 PSI (20,700kPA) rating
Grout Spec.: only required to keep sensors parallel to floor
Max. Longitudinal Slope: 1/4 in. per ft. (21 mm/m)
Max. Lateral Slope: 1/16 in. per ft. (5 mm/m)
Pedestal Location: 36-96 in. (914-2438 mm) from QT1

Product Specifications

Max. Wheel Weight: 3500 lb. (1588 kg) per wheel
Test Entry Speed: 2 to 8 mph (3-13 km/h)

Shipping Weight

Quick Check Cabinet: 290 lbs (132 kg)
Quick Check Drive Under Sensor: 316 lbs (143 kg)
Quick Tread: 530 lbs (241 kg)